Home / News

State Grid Commissions World-First IGBT Static Power Generator to Stiffen Renewable-Heavy Grids

Date:11-21-2026

State Grid commissioned a 35 kV / 30 MVA IGBT-series static power generator at the Fanghe 330 kV substation in Yan'an, Shaanxi, on 20 November 2026, the first unit of its kind anywhere. It follows a 168-hour trial run and artificial short-circuit tests at both 110 kV single-phase and 35 kV three-phase outlet faults.

The device, called SPG for stationary power generator, does a job that until now required a synchronous condenser: injecting reactive current and short-circuit capacity into weak grid nodes so that inverter-based renewable generation can ride through disturbances. China's grid code has tightened voltage-support requirements as wind and solar share climbs, and northern Shaanxi is one of the places where the problem is most acute, with coal and renewables concentrated far from load centres.

Key specifications

  • Rating: 35 kV, 30 MVA; installed at a 330 kV substation
  • Topology: isolated energy storage feed plus a high-voltage direct-hung IGBT series converter valve, an AC-DC decoupled two-stage arrangement
  • Against a conventional modular cascaded converter valve: 50% fewer devices, 70% less capacitance and 90% smaller footprint
  • Response verified across transient, dynamic and steady-state timescales, with controllable current output during faults
  • Grid impact: 50 MW more renewable output absorbable in northern Yan'an, about 60 GWh of additional annual feed-in, roughly the yearly consumption of 20,000 households

Why it matters

Two things are being displaced at once. The engineering answer to weak grids has been the synchronous condenser, a spinning machine that provides inertia and short-circuit current but is slow to site, large and expensive. The commercial answer has been the static var compensator or STATCOM, which is fast but supplies no real short-circuit capacity. The SPG sits between them: no rotating mass, but explicit real-current injection during faults.

The 90% footprint reduction is the number that matters for procurement. Substations in dense coastal load centres and remote desert renewable bases both struggle to find land, and a container-sized device that replaces a hall-sized machine changes the economics of retrofits. The developer, a joint team from the China Electric Power Research Institute's grid stability and flexible AC transmission groups, says the IGBT series valve breaks a foreign monopoly that has held for three decades on high-capacity series conversion.

State Grid has already flagged the commercial roadmap: 66 kV to 110 kV versions, aimed at the desert renewable bases of the northwest, HVDC sending and receiving ends, and load centres where conventional generation has retired. The equipment was admitted to China's sixth batch of first-of-a-kind major energy technology equipment in 2026.

What is not yet proven

One unit at one substation is a demonstration, not a fleet. Nothing has been published on cost per MVA, on availability, or on how the series-connected IGBT stack behaves over years of switching duty; series connection is precisely where redundancy and failure containment get difficult, and a single device failure can take the whole valve out of service if the bypass design is inadequate.

The 50 MW figure is also a system-level estimate for one substation, not a measured capacity release. Buyers comparing this against a synchronous condenser will want lifetime cost, maintenance interval and fault-current waveform data, none of which has been released.

Source

Reported by State Grid Corporation of China and the China Electric Power Research Institute, 20 November 2026. Chinese-language sources only; no English-language coverage of this commissioning was found at the time of writing.

Prev: Return to list

Next: Youlong Unveils Ruying Exoskeleton That Reads Fatigue and Mood From Gait